tional knowledge at handling with lifting devices and corresponding lifting
means. To ensure a safe use, these activities must be carried out by skilled
personnel or an instructed person under guidance of a skilled personnel.
A system designer must consider all relevant regulations and safe operation
of the system. All necessary regulations and safety measures must be imple‐
mented to ensure the safe installation and operation.
As additional qualification are needed:
●
Knowledge about wiring of electrical components
●
Knowledge about parameterization of application software
●
Basic knowledge about control engineering
2.5
General safety notes
●
Observe the valid regulations about accident prevention and environ‐
mental protection.
●
Pay special attention to the safety regulations and instructions of the
country in which the product is used.
●
Use Rexroth products only in proper technical state.
●
Please observe all notes on the product.
●
Persons, who assemble, operate, disassemble or maintain Rexroth
products must not be influenced by alcohol or other drugs which influ‐
ence the reactions.
●
Only use accessories and spare parts which are permitted by the manu‐
facturer to prevent from risk of injury due to unsuitable spare parts.
●
Keep the technical data and environmental conditions specified in the
product documentation.
●
If unsuited products are assembled or used in safety-relevant applica‐
tions, unintendend operation states can occur in the application, which
cause personal or material damage. Only use a product in safety-rele‐
vant applications if this application is particularly specified and allowed
in the documentation of the product.
●
You are allowed to operate the product if it is determined that the final
product (for example a machine or system), in which Rexroth products
are assembled, is according to the country-specific determinations,
safety regulations and standards of the application.
2.6
Product and technology-dependent safety instructions
Danger of life, risk of injury, heavy bodily
harm during work on a system which is under
pressure.
WARNING
●
Switch off all power-transmission-components and connections (electric,
pneumatic, hdydraulic) according to the manufacturer´s details and se‐
cure them against restarting.
●
Ensure that the motor-pump-unit is completely depressurized.
●
Do not release any cable connections, connections and components as
long as the motor-pump-unit is under pressure.
Bosch Rexroth AG
DOK-SYTROX-MPES2******-IT01-EN-P
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
20/143
Safety notes
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
