140
Bosch Rexroth AG
| Tightening Technology
3 608 878 300
System 350
| 3 608 878 300/2019-03
5.2.2
Output signals
Ack0-7
Acknowledge 0-7: Acknowledges the program or application selection
Output signal used for:
•
Tightening channel (
Ack0-7
)
•
Communication unit in single-channel operation (
CH x.y Ack0-7
)
•
Communication unit in application operation (
FO x Ack0-7
)
The signal acknowledges the program and application selection.
With the help of this signal, the PLC can determine whether the tightening program or tightening
application was selected successfully. A program or application number is only valid once the
acknowledgment corresponds with the selection. The controller always uses the acknowledged program
number as the basis for a tightening.
ActEnAck
Active Enable: Acknowledges enabling of a single tightening process
Output signal used for:
•
Tightening channel (
ActEnAck
)
•
Communication unit in single-channel operation (
CH x.y ActEnAck
)
The signal serves to confirm that the tightening channel has been enabled for a single tightening process.
AnglH
Angle too high: Angle too high
Output signal used for:
•
Tightening channel (
AnglH
)
•
Communication unit in single-channel operation (
CH x.y AnglH
)
Results description after a completed tightening sequence. The angle is above the defined tolerance
window.
AnglL
Angle too low: Angle too low
Output signal used for:
•
Tightening channel (
AnglL
)
•
Communication unit in single-channel operation (
CH x.y AnglL
)
Results description after a completed tightening sequence. The angle is below the defined tolerance
window.
AnglTotH
Angle total too high: Total angle too high
Output signal used for:
•
Tightening channel (
AnglTotH
)
•
Communication unit in single-channel operation (
CH x.y AnglTotH
)
Results description after a completed tightening sequence. The global angle is above the defined
tolerance window.
AnglTotL
Angle total too low Total angle too low
Output signal used for:
•
Tightening channel (
AnglTotL
)
•
Communication unit in single-channel operation (
CH x.y AnglTotL
)
Results description after a completed tightening sequence. The global angle is below the defined
tolerance window.
Only bits 0-5 can be used.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
