3 608 878 300
Tightening Technology |
Bosch Rexroth AG 153
System 350
| 3 608 878 300/2019-03
StickSlipH
Stick Slip too high: Number of stick slips too high
Output signal used for:
•
Tightening channel (
StickSlipH
)
•
Communication unit in single-channel operation (
CH x.y StickSlipH
)
Results description after a completed tightening sequence. The number of stick slips is above the defined
tolerance window.
TimeH
Time too high: Time too high
Output signal used for:
•
Tightening channel (
TimeH
)
•
Communication unit in single-channel operation (
CH x.y TimeH
)
Results description after a completed tightening sequence. The time is above the defined tolerance
window.
ToolBn
Tool button: Status of the tool button on the ErgoSpin
Output signal used for:
•
Tightening channel (
ToolBn
)
•
Communication unit in single-channel operation (
CH x.y ToolBn
)
This signal shows the status of the tool button on the ErgoSpin. Holding down the tool button keeps the
signal at "high", releasing it changes the signal to "low".
TorqAvrH
Torque average too high: Average torque value too high
Output signal used for:
•
Tightening channel (
TorqAvrH
)
•
Communication unit in single-channel operation (
CH x.y TorqAvrH
)
Results description after a completed tightening sequence. The average torque value is above the defined
tolerance window.
TorqAvrL
Torque average too low: Average torque value too low
Output signal used for:
•
Tightening channel (
TorqAvrL
)
•
Communication unit in single-channel operation (
CH x.y TorqAvrL
)
Results description after a completed tightening sequence. The torque average value is below the defined
tolerance window.
TorqCtrH
Torque control too high: Tightening torque too high
Output signal used for:
•
Tightening channel (
TorqCtrH
)
•
Communication unit in single-channel operation (
CH x.y TorqCtrH
)
Results description after a completed tightening sequence. The maximum torque control is above the
defined limit.
CAUTION
The StartBn signal is to be used with caution. The PLC has the sovereignty to start tightening
programs that are rotating clockwise or counter-clockwise directly one after the other.
This signal is only active for tightening channels with ErgoSpin. The signal is only updated outside of the
tightening operation.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
