3 608 878 300
Tightening Technology |
Bosch Rexroth AG
19
System 350
| 3 608 878 300/2019-03
2.1.2
Instructions for use
To prevent injury and/or damage to equipment, read the following instructions before commissioning the
Rexroth tightening system and components. These safety instructions must be observed at all times.
•
Bosch Rexroth AG does not assume any liability for damages resulting from non-compliance with the
safety warnings in this documentation and in the documentation of all the Rexroth tightening system
components.
•
Read the operating, maintenance, and safety instructions prior to commissioning. If the
documentation in the available language is not clearly understood, please contact the supplier and
inform him of this.
•
The prerequisites for correct, safe operation of the Rexroth tightening system are: proper
transportation, storage, assembly, and installation, as well as careful operation and maintenance.
– Check the product for visible defects, for example cracks in the housing or missing screws and
seals.
– Before commissioning, make sure that all the connection gaskets and plugs are installed correctly
to ensure that they are leakproof and fluids and foreign bodies are prevented from penetrating the
product.
– Make sure that all electrical connections are either used or covered. Commission the product only
if it is installed completely.
– Only use Rexroth products within the performance range specified in the respective technical
data.
– Do not expose Rexroth products to any mechanical loads under any circumstances. Never use
Rexroth products as a handle or step. Do not place any objects on Rexroth products.
•
Only use accessories and spare parts that are approved by the manufacturer.
•
Observe the safety regulations of the country in which the Rexroth tightening system and
components are used.
•
Rexroth tightening system components are designed for installation in machines used in industrial
applications.
•
Always observe the ambient conditions specified in the product documentation of the respective
component.
– Let new components acclimate for several hours before commissioning. Otherwise, water may
condense, e.g. in the control housings.
– Make sure that all electrical connections are either used or covered. Commission the component
only if it is installed completely.
•
Safety-relevant applications are only permitted if they are clearly and explicitly stated in the planning
documents. If this is not the case, they are excluded.
Safety-relevant applications are all applications that may result in injury to personnel or damage to
equipment.
•
In the respective product documentation, information is provided regarding use of the supplied
components. These are application examples and suggestions only.
The machine manufacturer and system installer must check that
– the supplied components and specifications made in the respective documentation are suitable
for the application on hand, and that they
– correspond to the safety regulations and standards valid for that application. The machine
manufacturer and system installer must implement the required measures, modifications, and
expansions.
•
Commissioning of the supplied components is prohibited until it has been determined that the
machine or system in which they are installed corresponds to country-specific provisions, safety
regulations, and standards for the specific application.
•
Operation is only permitted in accordance with the national EMC regulations for the respective
application.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
