200
Bosch Rexroth AG
| Tightening Technology
3 608 878 300
System 350
| 3 608 878 300/2019-03
6.1.3
Identification codes
The results data record of a tightening is uniquely identified for internal or external further processing
using an identification code (ID code) and can thus be assigned to the tightened component. The ID-code
can contain up to 64 ASCII characters, such as parts of a part number, production number, serial number,
chassis number, etc.
The ID code is transferred to the controller before the tightening process is started. The internal cycle
counter can be used for identification as an alternative to an ID code.
6.1.3.1
Selection of the source for ID-codes
The source of the ID codes is defined in the BS350 operating system under
System
Tightening cell
data
ID code
by selecting the desired source in the
Device selection
field.
Fig. 6–2:
ID code source selection
The exact number of available options depends on the configuration of your tightening controller (KE, SE,
CS). There are the following options:
1
Device selection
2
Delete ID code after start
3
Extend ID code with sequence number
4
Use channel-specific ID code in application operation
Table 6–2:
Select ID code source
Device selection
Description
KE (IL)
CS351x-
x (IL)
CS351x-
D NK
SE
No ID code
No ID code will be entered in the results data
record.
X
X
X
X
Cycle counter
The internal cycle counter numbers are used to
create the ID code.
X
X
X
X
Ethernet/FTP
A file with a character sequence to create the ID
code is expected
X
X
X
PLC 3964R
ID codes can be transferred to the controller via a
serial interface that has been configured for
protocol 3964R
.
X
X
X
Scanner
The bar codes
STX prefix
and
ETX suffix
are used
to form the ID code, see note.
X
X
X
X
Field bus (A slot)
An ID code can be transferred to the controller via
the field bus
.
X
X
X
Open Protocol
The ID code can be transferred to the controller
via the Rexroth Open Protocol
.
X
X
X
2
4
3
1
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
