3 608 878 300
Tightening Technology |
Bosch Rexroth AG
29
System 350
| 3 608 878 300/2019-03
DANGER
Dangerous movements!
Danger to life, risk of serious injury or damage to equipment!
Ensure personal safety, either by means of monitoring devices or by superior measures directly
on the system.
The measures depend on the specific system conditions and are determined based on a risk and
error analysis. The safety regulations applicable to the system must be taken into consideration.
Unintended machine movements or other malfunctions may occur when the safety equipment is
switched off, bypassed, or not activated.
Preventing accidents, injury, and/or damage to equipment:
Do not enter the machine's and machine parts' area of travel. Possible measures to prevent
unintended entry of persons include:
– Protective barriers
– Protective enclosures
– Protective covers
– Photocells
Barriers and covers must be rigid enough to withstand the maximum possible momentum.
The emergency OFF switch must be easily accessible in the immediate vicinity. Check the
function of the emergency OFF system before commissioning. If the emergency OFF switch
malfunctions, do not operate the device.
Protection against unintended start-up by means of an emergency OFF circuit.
Safely bring the drives to a standstill before accessing or entering the danger zone.
Additionally secure vertical axes from falling or dropping after the motor is switched off by:
– Mechanical lock on the vertical axis
– External braking/catching/clamping device
– Sufficient weight compensation of the axis
Switch electrical equipment to a de-energized state at the mains and protect it against being
switched on again during:
– Maintenance and repair
– Cleaning
– Long disruptions in operation
Avoid operating high-frequency, remote-controlled, or radio devices in the vicinity of the device
electronics and cables. If this cannot be avoided, check the device and the system for
malfunctions in all working positions. In some cases, a special EMC inspection of the entire
system may be necessary.
In the following cases, install a torque support at the ErgoSpin hand-held nutrunner:
– ESM as of 10 Nm
– ESA or ESV as of 40 Nm
Use a torque support if tightenings with higher torques are to be performed with a hand-held
tightening spindle.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
