290
Bosch Rexroth AG
| Tightening Technology
3 608 878 300
System 350
| 3 608 878 300/2019-03
6.4.1.2
Function diagram
Fig. 6–48:
Function diagram of data exchange via field bus
6.4.1.3
Exchanged data
The following data can be exchanged via the interface module:
•
Control signals from/to the partner controller
•
ID-codes for single channels (control unit/communication unit) and for tightening applications
(communication unit)
•
Tightening results from single-channel tightenings (control unit/communication unit), tightening
results from tightening applications (communication unit).
•
IL data for data exchange with the integrated logic via the
ControlFieldbus
function block.
A description of the control signals and their applications can be found in chapter
Tightening results are output for each tightening process. This is why a clear identification of the
tightening results is necessary, to be able to e. g. assign archived tightening results at a later point. The
Tightening System 350 allows the identification of each tightening result record with an ID code provided
by the partner controller.
Inputs
ID code
IL data
Partner
controller
Control signals
ID code
IL data
EN
CW
CCW
ABCDXXXX
EFG
1
1
0
41 42 43 44 58 58 58 58
45 46 47
IL data
Angle
Torque
Control signals
HIJ
135,85
°
101,100 Nm
CyCmp
OK
NOK
48 49 50
A4 BA 14 00
30 44 9A 00
1
1
0
Outputs
Results
IL data
CS351
KE350
Data exchange via the interface module can only be implemented if the data input/output field has been
configured and at least one control signal has been set.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
