3 608 878 300
Tightening Technology |
Bosch Rexroth AG
31
System 350
| 3 608 878 300/2019-03
2.6.6
Protection during handling and assembly
Under unfavorable conditions, handling or assembling specific parts in an unsuitable manner could cause
injuries.
2.6.7
Protection when handling batteries
Batteries consist of active chemicals surrounded by a rigid housing. Improper handling can thus result in
injuries or damage to equipment.
CAUTION
Risk of injury due to improper handling!
Injury due to crushing, shearing, cutting, impact!
Observe the general construction and safety regulations for handling and assembly.
Use suitable assembly and transport equipment.
Prevent trapping and crushing injuries by means of suitable provisions.
Only use suitable tools. Use special tools if stipulated.
Use lifting equipment and tools properly.
If necessary, use suitable protective equipment (for example, protective goggles, safety shoes,
protective gloves).
Do not stand under suspended loads.
Any fluids that have leaked onto the floor must be wiped up immediately to prevent slip hazards.
Lay cables and lines in accordance with the permissible bending radiuses so that they cannot be
damaged and no one can trip over them.
CAUTION
Risk of injury due to improper handling!
The improper handling of batteries may lead to chemical burns or explosions that can again lead to
injuries.
Never attempt to reactivate dead batteries by heating or other methods (risk of explosion and
chemical burns)!
The batteries must never be recharged, as this could cause them to leak or explode.
Do not incinerate batteries.
Do not take batteries apart.
Do not damage the electrical components installed in the devices.
Environmental protection and disposal: In the context of legal regulations, the batteries contained in this
product are to be considered hazardous materials when transported on land, by sea, or by air (risk of
explosion). Dispose of used batteries separately from other waste. Observe the national regulations of the
country where the product is installed.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...