3 608 878 300
Tightening Technology |
Bosch Rexroth AG 635
System 350
| 3 608 878 300/2019-03
Other deviations of the CC version in the BS350 standard operating system
Fig. 7–51:
CC-CS351 configuration
•
With the CC-CS351, module slot A is not displayed in the tightening channel configuration.
Interface modules in slot A are not supported by the channel configuration. For this reason, all field
bus functions are disabled.
•
With the CC-CS351, the "motor current transducer function" is set to
primary
and cannot be
adjusted.
The auto configuration sets the transducer function to "primary transducer" for the servo amplifier
and to "off" for the hand-held nutrunner. This cannot be changed. This is automatically done for
unconfigured systems following a restart.
•
The CC-ErgoSpin does not support the function "transducer test".
The "standard" ErgoSpin executes the transducer test outside of the tightening. The ErgoSpin reads
measured values from the measurement transducer.
The CC-ErgoSpin records measured values via the motor current when turning the spindle. For
operator safety reasons, this is not possible in the transducer test.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
