7
Basic commissioning
This document explains how to commission the Rexroth Tightening System 350 with
the sequence test. This includes commissioning the CS351 compact system with
ErgoSpin hand-held nutrunner or a tightening spindle, as well as commissioning the
modular system with a tightening spindle. Commissioning primarily consists of
system construction, setting up the programming interface (Ethernet or USB),
configuration of the tightening channel, and creating tightening programs with the
BS350 operating system. The connection of the tightening cell to a partner controller
(PLC) is not the subject of this chapter.
For information on the integrated logic, see in the "Project planning" documentation
of the Rexroth Tightening System 350.
•
•
Assembling the tightening cell
•
Connecting the PC for programming
•
•
•
•
Saved ("automatic") channel configuration
•
Special operating features of the hand-held nutrunner ErgoSpin/CC-ErgoSpin
•
Special characteristics of Nexo cordless Wi-Fi nutrunner operation
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...