3 608 878 300
Tightening Technology |
Bosch Rexroth AG 539
System 350
| 3 608 878 300/2019-03
7.3.4
Setting up the programming interface
7.3.4.1
USB interface
The USB interface drivers must be installed separately. The necessary files and instructions for this can
be found on the USB stick provided with the tightening system (hereafter referred to as the
"system stick").
To select the USB interface:
1.
Make sure that the PC is connected to the compact system via the USB cable (interface X3U3 at the
front).
2.
Click
PC
Interface
in the BS350 operating system.
3.
Select the
USB
interface.
4.
Click
OK
to accept the setting.
5.
Click
System test
Tightening channel info
to test the connection.
7.3.4.2
Ethernet interface
In order to operate the tightening system via Ethernet, the PC has to be equipped with an Ethernet
interface card for network operation.
The Ethernet interface in the compact system has the following settings by default:
•
IP address: 192.168.1.1
•
Subnet mask: 255.255.255.0
•
Host name: cell
The rest of the settings are either 0.0.0.0 or empty.
If the connection is not established, you can reset all connection parameters without closing the BS350.
Proceed as follows:
Disconnect the USB cable from the interface.
Reinsert the USB cable in the interface.
Go to the
PC/PC interface
window and click the
Reset
button.
If the connection is not established, you can reset all connection parameters and close any open
connections, without closing the BS350. Proceed as follows:
Go to the
PC/PC interface
window and click the
Reset
button.
Summary of Contents for Rexroth Tightening System 350
Page 4: ...4 641 Bosch Rexroth AG Schraubtechnik System 350 3 608 878 300 2019 03 ...
Page 120: ...120 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 194: ...194 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
Page 638: ...638 641 Bosch Rexroth AG Tightening Technology 3 608 878 300 System 350 3 608 878 300 2019 03 ...
