INSERTING AND RELEASING BATTERy PACK
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 12).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 12).
-11-
“VARIO-LOCK”
Choose a position which is best suited for your
operation. The Vario-Lock position is intended
for use with chipping bits such as bull points,
spades, gouges, etc.
Turn the mode selector dial, to the “vario-
lock” setting. Next, rotate the locking sleeve,
along with the accessory, to the desired
position. Then turn the mode selector dial to
the “hammer only” setting and slightly turn
the locking sleeve to have it automatically
lock into a definite position (Fig. 11).
SLIP CLUTCH
The tool has a internal pre-set slip clutch. The
output spindle will stop rotating if the accessory
binds and overloads the tool.
BRAKE
When the trigger is released it activates the
electrical brake to stop the chuck quickly. This
is especially useful in the repetitive driving and
removal of screws.
1
2
FIG. 12
1
2
FIG. 11
BM 2610034452 03-14_RHH181 3/27/14 12:35 PM Page 11
