Start-up
Ensure that you have a Bosch Smart Home control-
ler and the Bosch Smart Home app and have suc-
cessfully configured both. Now start the Bosch Smart
Home app and select “Add new device”. Follow the
instructions in the app.
Resetting to factory settings
You can reset the device to its factory settings as
follows:
Open the battery compartment (8) and remove one
of the batteries. Replace the battery while holding the
rotary knob (4) pressed. Hold the knob pressed until
the status LED (3) on the room thermostat flashes
orange and “RES” appears on the display. Now
release it briefly and press the knob again and hold
until the LED lights green. The device then restarts.
Please note that it can take a few seconds until the
room thermostat is ready for operation again.
When resetting to factory settings, the settings
and information are only lost from the device
and not from the Bosch Smart Home controller.
To re-configure the device, first delete it in the
device management section of the Bosch Smart
Home app and then add it again in the usual
configuring process.
