Troubleshooting
aus
49
Fault
Cause and troubleshooting
Tableware is not dry.
1.
Use rinse aid to improve drying performance.
2.
Use a different combined detergent with a better
drying performance.
Extra Dry not activated to improve drying perform-
ance.
▶
Activate Extra Dry →
.
Tableware removed too early or drying process not
yet ended.
1.
Wait until the programme ends.
2.
Only remove tableware 30 minutes after the pro-
gramme has ended.
Rinse aid used has a limited drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited effectiveness.
Appliance door does not open automatically at the
end of the programme
▶
Adjust the appliance door as described in the in-
stallation instructions.
The door gap must be at least 70 mm - 100 mm.
Plastic tableware is
not dry.
Not a fault. As plastic does not store heat so well, it
also does not dry as well.
▶
No remedial action possible.
Cutlery is not dry.
Cutlery not arranged properly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery contact points.
1.
Arrange cutlery individually where possible.
→
2.
Avoid points of contact.
Appliance interior still
wet after wash cycle.
Not a fault. The condensation drying principle causes
water droplets in the tub – they are indeed desirable
here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Food remnants are
left on tableware in
the top basket.
Tableware in the top basket was placed too close to-
gether or top basket is overfilled.
▶
Arrange tableware in the top basket with sufficient
space in between. Position large items of tableware
at an angle, e.g. pans and ovenproof dishes.
‒
Activate the Extra Clean Zone function in the top
basket.
→
Summary of Contents for SBI8EDS01A
Page 63: ......