Troubleshooting
aus
53
Fault
Cause and troubleshooting
Plastic parts are dis-
coloured.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food and do not
prerinse tableware.
▶
Adjust the sensitivity of the sensors.
→
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
Amount of rinse aid to be dispensed is set too high.
▶
Set the rinse aid system to a lower setting.
No rinse aid has been added.
▶
Detergent residue is present in the final rinse. Lid of
the detergent dispenser is blocked by tableware items
and will not open fully.
1.
Arrange tableware in the top basket tableware so
the tab collecting tray is not obstructed by table-
ware.
→
Items of tableware are blocking the dispenser lid.
2.
Do not place tableware or fragrance dispensers in
the tablet collecting tray.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food and do not
prerinse tableware.
▶
Adjust the sensitivity of the sensors.
→
Irreversible clouding
of glassware.
Glasses are not dishwasher-proof, only suitable for
dishwashers.
▶
Use dishwasher-proof glasses.
Glasses are usually only suitable for use in a dish-
washer, i.e. long-term wear or long-term changes
must be expected.
▶
Avoid a lengthy steam phase (standing time after
wash cycle ends).
▶
Use a programme with a lower temperature.
▶
Use detergent with a glass protection component.
Rust spots on cutlery.
Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
▶
Use rust-resistant tableware.
Summary of Contents for SBI8EDS01A
Page 63: ......