Bosch SE3000 Series Technical Reference Manual Download

Page: 104 / 256

104

en | Troubleshooting coordinators, points and receivers

Security Escort

2018.03 | SE3v1.0 | DOC

Technical Reference Manual

Robert Bosch (SEA) Pte Ltd

Element

Usage/Description

Disable idle processing

Normally, this software registers with Windows to return to the
Security Escort system if there is any idle time. The Security Escort
system can use it to speed up its response to serial
communications and other background tasks. If selected, the
software will not register for the idle time. Normally, this checkbox
is not selected.
Windows can show the amount of time each application (task) is
taking. When this checkbox is not selected, it may appear that
Security Escort system is “hogging” the processor resources. This
is not true, because the Security Escort system is only taking the
time that Windows gives it through the idle process.
To prove this, select this checkbox. The amount of time that the
Security Escort System needs will drop dramatically, and it will
continue to operate normally (same communications responses
will be slowed by several hundred milliseconds).

Enable algorithm
tweaks

Selecting this checkbox causes the

Map scale

Alarm spot size

and

Linear/Low/Medium/Strong depth

settings to be visible on

this dialog. It also controls the display of the

SA%

and

Algorithm

settings in the

Edit Transponder

’

s Database Record

dialog.

ID Receiver / Point

Assign an SE receiver for automated transmitter exchanges. The
Security Escort system contains a feature where the transmitter
identification number can be automatically entered into the

Subscriber database

. This is used for entering transmitters when

issuing them to subscribers for the first time, and for transmitter
exchanges.
This automatic capture of the transmitter identification number is
accomplished by performing certain procedural steps (see the
Security Escort Operation Manual) and then using the transmitter to
make a test transmission in close proximity to a designated SE
receiver, usually located close to the Central Console.
By capturing the transmitter identification number in this manner,
keystroke errors are avoided during database entries and changes.
The SE receiver chosen for this purpose is designated as the

Capture Receiver

. To assign the

ID Capture Receiver

, its SE

coordinator name and its

Point Number

are selected using the

Receiver

and

Point elements.

Control room / Point

The Security Escort system software can activate an output to
attract attention, when there is an alarm that has been received,
and no operator has responded to the system yet. To assign the
output, select the SE coordinator that it is connected to, and the

Point Number

Map scale %

This value changes the scale that the maps are presented with. It is
not intended for normal operation, but typically used for testing to
allow more of the map to be seen. The setting may range from 30%
to 400%. The

Enable algorithm tweaks

checkbox must be selected

for this to be visible.