1. Remove the screw from the slide cover.
2. Remove the slide cover from the enclosure.
3. Insert the battery, placing the + (positive)
side of the battery away from the enclosure.
4. Ease the slide cover into position and press
to snap it in place.
5. Insert the screw on the slide cover and
tighten.
6. Test the transmitter for proper operation.
Important Information for Users of
Security Escort System
Protected Areas
Check with the security department to verify the
exact areas of the facility that are protected by
the system and those that are not.
Lost or Stolen Transmitters
If your transmitter is lost or stolen, report the in-
cident immediately to the security office so a re-
placement can be issued and the original trans-
mitter can be deleted from the system.
Tips for Better Transmission
As with all radio equipment, the signal strength
from the transmitter is reduced by metal and
wet surfaces and to some extent by the human
body.
Battery Life
Assuming normal usage (such as weekly test-
ing), the battery lasts approximately one year. If
the battery is weak, a special signal is sent to
the security office during a test. This test will
not produce a flashing light on the receiver or
siren/strobe.
Exposure to Moisture
Test the transmitter a few times (several hours
apart) once exposed to moisture to verify it is
working properly.
9 |
10 |
11 |
12 |
13 |
14 |
SE88A Series Asset Transmitters
SE88A-90S-304
en
User Manual
Robert Bosch (SEA) Pte Ltd
11 Bishan Street 21
573943 Singapore
Singapore
www.boschsecurity.com
© Robert Bosch (SEA) Pte Ltd, 2016
Bosch Sicherheitssysteme GmbH
Robert-Bosch-Ring 5
85630 Grasbrunn
Germany
© Bosch Sicherheitssysteme GmbH, 2016
F.01U.318.126 | V1.1
