17
BOSCH
* Model dependent
EN
gl
ISH
Trouble shooting
problem
probable cause
Solution
The iron does not
heat up.
1. Temperature control (12) set to
minimum.
2. The “secure” system has been
activated. The iron is set to
stand-by.
3. The “SensorSecure” system has
been activated. The iron is set to
stand-by.
1. Turn to a higher position.
2. To reconnect the iron, just move it about
gently.
3. Grip the handle of the iron to re-start it.
“auto off” indicator
lamp (15*) flashes.
1. The “secure” system has been
activated. The iron is set to
stand-by.
1. To reconnect the iron, just move it about
gently.
“SensorSecure”
indicator lamp
(16*) flashes.
1. The “SensorSecure” system has
been activated. The iron is set to
stand-by.
1. Grip the handle of the iron to re-start it.
The clothes tend
to stick.
1. The temperature is too high.
1. Turn the temperature control (12) down
and wait until the iron has cooled down.
Water drips out of
the soleplate (7)
together with
steam.
1. Temperature control (12) setting
is too low.
2. Steam regulator (3) is set too
high in conjunction with a low
temperature.
3. You have pressed the shot of
steam button (2) repeatedly
without waiting for 5 seconds
between each press.
1. Turn the temperature control to a higher
setting (between “••” and “max”) and wait
until the pilot light (13*) goes out.
2. Set the steam regulator (3) to a lower
setting.
3. Wait 5 seconds between each press of
the shot of steam button.
Steam does not
come out.
1. Steam regulator (3) is set to
[
]
position.
2. The temperature is too low.
Anti-drip system is activated.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if compatible
with the fabric.
Smoke comes out
when connecting
the iron for the first
time.
1. This may be caused by the
lubrication of some of the internal
parts.
1. This is normal and will stop after a few
minutes.
Deposits come out
through the holes
in the soleplate
(7).
1. Traces of lime scale are coming
out of the steam chamber.
1. Carry out a cleaning cycle (see
“Calc’nClean” section).
If none of the above solves the problem, get in touch with an authorised technical service.
