Bosch SGE63E06UC - Evolution 24" Special Application Dishwasher FR Operating Instructions Manual Download

Page: 22 / 70

Problem

Cause

Action

Dishwasher not
filling with water

1.  Restriction in the water supply system.
2.  Previous wash cycle was not completed.
3.  Delay-start is active.

1. Ensure that the water supply valve (typically located under kitch-

en sink) is open and check that the water supply line has no kinks

and clogs.

2. Refer to the “Canceling or changing the cycle” section of this

manual.

3. Cancel the delay-start or wait until delay-start time completes

(times out). Refer to the “Delay Start” section of this manual.

Water Leaks

1.  Suds
2.  Door seal could be pulled away from track.
3.  Condensation vent is blocked.
4.  Improper installation.

1. Wrong type of detergent results in suds and leaks. Use only

dishwasher detergents. If suds still persist, then add one ta-
blespoon of vegetable oil at the bottom of the dishwasher
and run the desired cycle.

2. Ensure that door seal is in the track.
3. Ensure that condensation vent is not blocked. Refer to “Load-

ing Extra Tall Items” in the Preparing and Loading the Dish-
washer section of this manual.

4. Have proper installation verified by qualified personnel (wa-

ter supply, drain system, leveling, plumbing).

Tub stains

1. Stains on the dishwasher interior are due to hard-

ness of water.

2. Silverware in contact with tub.

1. Concentrated Lemon juice can reduce the build up of hard

water stains. Run a normal cycle until it flushes and interrupt
the cycle and then place an 8 oz. cup of the concentrated
lemon solution on the top rack and finish the cycle. This can
be done periodically to avoid build up.

2. Ensure that the silverware does not make contact with the

tub while running a cycle.

Streaks on glass-
ware or residue
on the dishes

Incorrect rinse agent setting.

Depending on the hardness of water, adjust the rinse agent dis-
penser. Refer to “Adding Detergent and Rinse Agent” section in this
manual for adjustment.

Fascia panel
discolored or
marked

Abrasive cleaner used.

Use mild detergents with soft damp cloth.

Noise during
wash cycle

The dishes may not be arranged properly.

Water circulation sound is normal, but if you suspect items are
banging into each other or into the spray arms, refer to the “Pre-
paring and Loading” section of this manual for optimal arrange-
ment.

Detergent dis-
penser cover will
not shut

1. Improper operation of detergent cover.
2. Previous cycle has not been finished, reset, or cycle

was interrupted.

1. Refer to “Adding Detergent and Rinse Aid” section of this man-

ual for instructions on opening and closing the dispenser.

2. Refer to the “Canceling or changing the cycle” section of this

manual.

Unable to select
desired cycle

Previous cycle has not finished or another cycle has
already started.

Refer to the “Canceling or changing the cycle” section of this
manual.

Error Codes

If fault code (E01 to E30) is indicated on the digital display 3 , first disconnect the appliance from the power supply. You can