Bosch SGS 46M22, Instructions For Use Manual

en

16

Note

Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.

Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.

Note

Even if the rinse aid and/or salt refill
indicator is lit, the rinse programme runs
correctly when 3in1 products are used.

If the rinse aid refill indicator 

7

 or salt

refill 

6

 indicator is defective and you

would like to switch it off, proceed as
follows:

Switching the rinse aid refill
indicator off and on

You can switch the rinse aid refill indicator

7

 on or off. This function can be

changed as follows.

Close the door.
Hold down the programme button 

C

and press the main switch 

1

 until the

digital display lights up, then release the
buttons.

3

 is indicated on the digital display

 (rinse aid refill indicator on).

By pressing the programme button

C

, you can switch off 

 or switch

on

 the rinse aid indicator.

Switch off the main switch 

1

;

the setting is saved.

Switching the salt refill
indicator / water softening
system off and on

Close the door.
Hold down the programme button 

B

and switch on the main switch 

1

,

then release the buttons.
The illuminated button 

B

 and the

factory-set value 

 on the digital

display flash.

To change the setting: press the
programme button 

B  

.

Each time the button is pressed, the set
value increases by one; when the value

 is reached, the display jumps back

to 

 (the salt refill indicator / water

softening system has been switched
off).
Switch off the main switch 

1

.

The set value is stored within the
device.

Approx. 4 litres of water are required to
regenerate the water softening system.
As a result, the water consumption per
rinse cycle increases by 0 to maximum
4 litres depending on the water hardness
setting.

Note

If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
hardness.

Downloaded from DishWasher-Manual.com Manuals