Rinse System NL
Regenerate the softening
system
Filling rinse aid
If the rinse aid refill indicator lights up,
add rinse aid. Only use rinse aid for
household dishwashers.
In order to maintain trouble-free
operation of the water softening system,
the device regularly performs a
regeneration of the water softening
system.
The softening system is regenerated in
all programs before the end of the
main wash cycle. This increases the
running time and consumption values
of, for example, water and electricity.
1.
Press and lift the tab on the lid of
the rinse aid reservoir .
2
Overview of the consumption values
when regenerating the
softening system
Here you will find an overview of the
maximum additional runtime and
consumption values when regenerating
the softening system.
1
2.
Top up the rinse aid up to the max
mark.
Regenerating the softening
system after x washes
6
Additional running time in minutes
More water consumption in litres
More power consumption in kWh
7
5
0.05
The stated consumption values are
laboratory measured values which
are determined according to the
currently valid standard and on the
basis of the Eco 50° program and the
factory-set water hardness value of 13
- 16 °dH.
max
3.
If rinse aid has spilled over, it must
be removed from the rinse aid
container.
G
Rinse System
lance flushing system
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
Rinse System
rinse aid
4.
Close the lid of the rinse aid
reservoir.
For optimal drying results
rinse aid
a The lid audibly clicks into place.
it is best to use gloss.
Only use gloss
for household v
rinse aid
dishwashers.
25
