Troubleshooting
en
41
Fault
Cause
Troubleshooting
Appliance interior still wet
after wash cycle.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
No action required.
Remnants of food on table-
ware.
Tableware is placed too
close together or basket is
overfilled.
1.
Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2.
Avoid points of contact.
Spray arm rotation is
blocked.
▶
Arrange tableware so that it does
not obstruct spray arm rotation.
Spray arm nozzles are
blocked.
▶
Filters are soiled.
▶
Clean the filters.
Filters are inserted incor-
rectly and/or not engaged.
1.
Insert the filters properly.
2.
Engage the filters.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
Tall narrow receptacles in
corner areas are not rinsed
adequately.
▶
Do not position tall narrow recept-
acles at too great an angle or in
corner areas.
Top baskets on right and left
are not set to same height.
▶
Set the top baskets on the left and
right to the same level.