Basic settings
en
33
Basic settings
Basic settings
Basic settings
You can configure the appliance to meet your needs.
Overview of basic settings
The basic settings depend on the features of your appliance.
Basic setting
Selection
Description
Water hardness
Scale with 4 levels
Set the water hardness.
Rinse aid disp.
Scale with 4 levels
Set the amount of rinse aid to
be dispensed or switch off.
Extra Dry
On
Off
1
Switch Extra Dry on or off for
each operation.
For a better drying result the
temperature in the final rinse is
increased. This may increase
the running time slightly.
Note:
Please take care with del-
icate tableware.
Tone volume
Scale with 4 levels
Adjustment of tone volume.
Factory setting
Reset
Restore changed settings to the
factory settings.
The settings for initial start-up
must be configured.
1
Factory setting (may vary according to model)
Setting Extra Dry
1.
Press .
2.
To open the appliance settings,
press
for 3 seconds.
a
is flashing on the display.
3.
Press
repeatedly until
and
flash in the display.
4.
Press
repeatedly until the
LEDs show the right value.
If "LED A" →
is not lit, Ex-
tra Dry is switched off.
If "LED A" →
is lit, Extra
Dry is switched on.
5.
To save the settings, press
for 3 seconds.