Softening System NL
2.
When using for the first time: fill the
reservoir completely with water.
According to the manufacturer's
instructions, you can only use
dishwasher detergents with salt
substitutes up to a degree of
hardness of 21 °dH without adding
softening salt.
s The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
3. Note: Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
1.
on
to press.
2.
To access the device settings,
press . for 3 seconds
to press.
a
a flashes in the display.
3.
Press as many times until there
no more LED lights up (position 0).
4.
To save the settings, press for
approx. 3 seconds.
a The water softener has been
switched on and the refilling salt
indicator is deactivated.
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
4.
Fit and close the lid of the
reservoir.
Regenerate the softening
system
Switch off water softening
In order to maintain trouble-free
operation of the softening system,
the device regularly performs a
regeneration of the softening system.
The softening system is regenerated
in all programs before the end of the
main wash cycle. This increases the
running time and the consumption
values of, for example, water and
electricity.
If the refilling salt display bothers you,
for example if you use a combined
dishwasher detergent with a salt
component, you can switch off the
display.
Remark
To avoid damage to the appliance,
only switch off the water softening
in the following cases:
s
The water hardness is a maximum
of 21 °dH and you use a combined
dishwasher detergent with salt
substitutes. combined
1
Depending on the device version
23
