12
Check water inlet
Sensors OK Spray pressure Do not open door
Sanitation rinse
Drying
Rinsing
Washing
Program progress
Operating the Dishwasher
Start the dishwasher:
1
Open the door and press the
On/Off
button.
2
Select a cycle and desired options.
3
Close the door to begin the cycle.
Delay start:
1
Open the door and press the
On/Off
button.
2
Select a cycle.
3
Press and hold the
Delay Start
button. Release when the desired delay time is shown in the display window.
4
Close the door to begin the cycle.
Cancel a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press and hold the two buttons labeled
Cancel/Reset
for 3 seconds.
3
Close the door and wait about 1 minute while the dishwasher drains.
4
Open the door and press the
On/Off
button. You may now start a new cycle
.
WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CARE-
FULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped.
Interrupt a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press the
On/Off
button to turn the unit off.
3
Wait at least 10 seconds before fully opening the dishwasher door.
4
To resume the cycle, press the
On/Off
button and close the dishwasher door.
Extra Dry Heat:
1
Press and hold the
Auto
button, then press and hold the
On/Off
button.
2
When the LED display window indicates a “0” or “1” release both buttons.
3
To activate Extra Dry Heat, press the
Auto
button until the display indicates “1”.
4
To disable Extra Dry Heat, press the
Auto
button until the display indicates “0”.
5
Press the
On/Off
button to save the setting.
Cycle completion signal:
The cycle completion signal alerts you when a cycle completes and the dishwasher has washed and dried the
dishes. You can choose to disable the tone or adjust the volume.
To activate:
1
With the unit OFF, press and hold the right of the two
Cancel/Reset
buttons and then press and hold the
On/
Off
button.
2
When the light on the
Cancel/Reset
button you are pressing illuminates and the tone goes off, release both buttons.
3
Press the right of the two
Cancel/Reset
buttons again until you achieve the desired volume or until there is
no tone (to turn cycle completion signal OFF).
4
Press the
On/Off
button to save the setting.
SHE55RF5UC, SHE68R5xUC and SHX68R5xUC front display key:
