21
WARNING
NOTICE
Avoid Scald Hazard
Do not perform any work on a charged hot water line. Serious injury
could result. Only qualified plumbers should perform plumbing work.
Do not attempt any work on the dishwasher hot water supply plumb-
ing until you are certain the hot water supply is shut off.
Temperatures required for soldering and sweating will damage the
dishwasher. If plumbing lines are to be soldered or sweated, keep the
heat source at least 6 inches (152.4 mm) away from the dishwasher.
Hot Water Supply
The hot water heater should be set to deliver approximately 120° F (49° C)
water to the dishwasher. Water that is too hot can cause some detergents
to lose effectiveness. Lower water temperatures will increase run times.
The hot water supply pressure must be between 15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
•
If using a solder joint instead of a compression fitting, be sure to make
all solder connections before connecting the water supply line to the
dishwasher.
•
Make sure there are no sharp bends or kinks in the water line that might
restrict water flow.
•
Always use the appropriate seal when making plumbing connections.
•
Before connecting the water supply line to the dishwasher, flush the
incoming water line for approximately 5 minutes to clear any foreign
material.
•
Turn on the water supply and check for leaks after connections are
made.
Water Inlet Connections
