Solution 6000
Installation Manual
Comms Programming
9-18
Bosch Security Systems 07/14 BLCC610I
Comms > MyAlarm >
Email Options
-
MENU 5-5-9
1
Open Close
Y
2
Zones
Y
3
System
Y
4
Access
Y
5
Reserved
N
6
Reserved
N
7
Reserved
N
8
Reserved
N
This menu allows the master user to select which event
types will be reported using the email reporting function.
By default the first 4 options are set to report via email.
Follow the procedure below to configure the required
options.
1)
Enter your Master PIN + [MENU].
2)
Enter [5] + [5] + [9] + [OK].
The keypad will display the list of current options.
Options with a preceeding tick mark are selected.
Open Close
Zones
System
Press
OK ON OFF MENU
3)
Use the [
] and [
] keys
to highlight the feature that
you want to program, then use the [ON] and [OFF]
keys to turn on and off the features as required.
4)
When all email options are programmed, press [OK]
to save and exit, or press [MENU] to exit without
saving
.
Open Close
This option allows the control panel to report ‘open’ and
‘close’ reports via email.
Zones
This option allows the control panel to report zone ‘alarm’
and ‘trouble' reports via email.
System
This option allows the control panel to report via email
numerous system reports (e.g. AC Fail, Low Battery etc)
via email.
Access
This option allows the control panel to report via email
when a valid token has been swiped eg. ‘Access Granted’
or ‘Access Denied’.
Comms > IP Reporting >
Receiver IP
MENU 5-6-0
Dest Nº 1
1
Digits
12
0 0 0
0 0 0
0 0 0
0 0 0
Dest Nº 2
1
Digits
12
0 0 0
0 0 0
0 0 0
0 0 0
This menu allows the installer to program the TCP IP
address for Destination 1 and/or Destination 2 so that
the control panel can communicate to the base station
receiver.
1)
Press [MENU] + [5] + [6] + [0]. The keypad will
prompt you to select which destination
(destination 1 or 2) that you want to program the
base staion IP addrress.
Rr1 Dest 1
Rr2 Dest 2
Exit
Press
OK or MENU
2)
Highlight the destination number (1 or 2) required,
then press [OK]to select.
3)
The keypad will display the first six digits of the
base station IP address.
Receiver IP Rr1
000000000000
Press 0-9 OK to SAVE
4)
Use the numeric keys [0] to [9] + [
←
] and [
→
] keys
to program the new MyAlarm IP Address, then
press [OK] to save and exit or press [MENU] to exit
without saving.
