4
2.0 DESCRIPTION
Environmental enclosures in the TC9346A Series are used with pan/tilt units or
fixed mounts.
The enclosures are constructed of aluminum.
You can install cameras with either fixed focal length lenses or motorized zoom
lenses. All models have an adjustable camera sled to accommodate different sizes
of cameras and lenses.
2.1 MODELS
TC9346A
Environmental enclosure with rear-opening lid. Lid has gas
spring to hold it open. 29-inch (73.66 cm) length.
TC9346A-1
TC9346A with 120 VAC thermostatically controlled heater and
blower.
TC9346A-2
TC9346A with 24 VAC thermostatically controlled heater and
blower.
TC9346A-3
TC9346A with 230 VAC thermostatically controlled heater and
blower.
2.2 OPTIONAL ACCESSORIES
You can order the following optional accessories for the TC9346A Series en-
closures:
BK57-1*
Blower kit, 120 VAC, 15 watts
BK57-2*
Blower kit, 24 VAC, 10 watts
BK57-3*
Blower kit, 230 VAC, 15 watts
HK57-1*
Heater kit, 120 VAC, 90 watts
HK57-2*
Heater kit, 24 VAC, 50 watts
HK57-3*
Heater kit, 230 VAC, 70 watts
O/I-PCB
Circuit board with thermostats
O/I-LPP*
Preset position lens wire harness (must be used with O/I-PCB)
O/I OUTLET*
120 VAC electrical outlet (must be used with O/I-PCB)
SS5729
Sun shroud
TI57
Thermal insulation kit
WD57-1*
Window defroster and defogger kit, 120 VAC, 30 watts
WD57-3*
Window defroster and defogger kit, 230 VAC, 30 watts
WD57-2*
Window defroster and defogger kit, 24 VAC, 30 watts
WW5729-1**
Window wiper kit, 120 VAC, 15 watts
WW5729-2**
Window wiper kit, 24 VAC, 15 watts
WW5729-3**
Window wiper kit, 230 VAC, 15 watts
* These accessories are factory wired with a plug-in connector for use with the
O/I-PCB. The O/I-PCB is included with all -1/-2/-3 models. You must order one
O/I-PCB if you are using a basic enclosure (TC9346A) with these optional
accessories.
** Factory installed option only; consult factory for availability.
