6
c.
Remove the four screws and washers (B and D) that secure the fan to
the fan plate.
d.
Turn the fan around so that it blows toward the viewing window (refer to
the arrows on the fan).
e.
Reinstall the fan on the fan plate.
f.
Reinstall the fan plate and fan in the enclosure.
g.
Reconnect the electrical plug on the fan.
h.
Close the enclosure lid.
i.
On the bottom of the enclosure, remove the vent grill (1) and filters (2) at
the front of the unit. Replace the grill with one of the vent covers that was
attached to the camera sled as loose equipment.
j.
On the bottom of the enclosure, attach the other vent plate over the grill
at the rear of the unit.
k.
Open the enclosure lid.
4.
If you are going to wire the enclosure with cable, remove the wiring glands and
nuts from the parts bag and install them in the bottom of the enclosure. If you
are going to wire the enclosure with conduit, do not install the glands.
5.
Mount the camera/lens to the sled with the 1/4-20 Phillips-head screws that
are provided in the parts bag. You can mount the camera to either side of the
U-shaped sled, depending on the camera height required.
6.
There are two threaded mounting holes on the bottom of the enclosure. Mount
the enclosure to a pan/tilt assembly or fixed mount with 1/4-20 screws with
threads that do not exceed 5/8 of an inch (1.59 cm) in length (not supplied with
the enclosure).
7.
Install the sled and camera/lens in the enclosure:
a.
If the camera’s lens is adjustable, extend the lens to its maximum length.
b.
Place the sled over the mounting screws in the enclosure.
c.
Slide the sled forward until the camera’s lens almost touches the window.
d.
Tighten the screws to secure the camera sled to the enclosure.
8.
Wire the video output from the camera.
9.
If you are going to synchronize cameras, wire the camera’s synchronization
connection.
10. If your camera has a motorized zoom lens control, wire it.
TC9346A Model Only –
Wire the camera’s lens control directly to the lens
controller.
TC9346A-1, -2, -3 Models Only
Refer to Figure 2 and wire the motorized zoom lens control as follows:
a.
Connect or wire the lens control from the camera to the LENS or LENS
CONTROL connector on the circuit board.
