English |
9
Bosch
TCC78K750 | 01/2009
Preparing milk froth
and warm milk
Risk of burns
The milk frother (12) gets very
hot. After use, allow to cool
down first before touching.
For optimal milk froth quality, use
cold milk with a fat content of at
least 1.5 % if possible.
Take the milk tube and connect it to the
milk frother (see “Preparation using milk”).
Place a cup or glass under the outlet of
the milk frother (12).
Select the required
Milk froth
or
Warm
milk
setting by turning the rotary knob
(5):
(
Milk froth
)
M
Press
o
start/stop
(10); milk froth or
warm milk runs out of the milk frother
outlet (takes about 40 or 60 seconds
respectively).
Press
o
start/stop
(10) again to cut the
process short.
The appliance may make a
whistling noise when warm milk is
being prepared. This is caused by
the milk frother (12) for technical
reasons.
Dried milk residue is diffi cult to
remove, so clean the milk frother
immediately after use
(see “Cleaning the milk system”).
1.
2.
3.
4.
Dispensing tea water
Risk of burns
The milk frother (12), from
which the tea water flows, gets
very hot. After use, allow to cool down
first before touching.
The appliance can also be used to prepare
tea.
Place a cup or glass under the coffee
outlet.
Select
Tea water
with the rotary knob
(5):
(
Tea water
)
L
a
}
Press
p
(4) to switch to the temperature
selection. Set the required temperature
with the rotary knob (5):
(
Tea water
)
L
c
}
Press
o
start/stop
(10); hot water runs
out of the milk frother outlet for about 40
seconds.
Press
o
start/stop
(10) again to cut the
process short.
Tip:
Warm up cups before use, especially
small, thick espresso cups, with the hot
water.
1.
2.
3.
4.