Bosch TCE 4540, Original Instructions Manual

1 695 105 790

2010-05-04

| 

Robert Bosch GmbH

34  |  TCE 4540  |  Use

en

5.1 Tire 

demounting

i

Read the Wdk publications available in German and 
English! 
(www.wdk.de: mounting/demounting instructions)

5.1.1 Wheel 

mounting

1. 

Deflate the tire completely.

2. 

Lower the wheel lifter with the appropriate pedal.

3. 

Put the wheel on the wheel support bracket.

652061-07_Mi

4. 

Lift the wheel with the wheel lifter pedal until the 
upper limit stop is reached (Fig. 3).

5. 

Push the wheel on the roller base until the wheel 
hub hole coincides with that of the locking flange.

652061-08_Mi

Fig. 3: 

Wheel lifting and movement towards the right.

5. Use

Warning - tire or rim damage danger!

Excessive pressure can e. g. result in cracks 
(on the inside/outside) of the tire. The rim 
can be scratched or deformed. 

Read the Wdk publications available in 
German and English! (www.wdk.de: moun-
ting/demounting instructions – criteria 
catalogue)

Inner temperature of the tire must be at 
least 15 °C (only in case of RFT/UHP).

Read the Wdk publications available 
in German and English! (www.wdk.de: 
mounting/demounting instructions – tire 
overheating)

Adjust pressure to the type of tire.

Plastic protection on the rim.

!

Before demounting or mounting operations it is ext-
remely important to collect all the rim and tire data. 
In this way it will be possible to know in advance the 
mounting, the pressure and the required accesso-
ries!

i

Remove all the balancing weights from the rim.

i

If the lowered well of the rim is on the lower part, a 
rubber cover must be applied for the tightening flange 
(see chap. 3.3) or the device for reversed rims (see 
chap. 3.4) on the tightening flange, because in this 
case the rim is turned while resting on the external 
side.