8
en
Robert Bosch Hausgeräte GmbH
14. Carefully pull out the milk frother (6) to
open it. The appliance rinses out the milk
frother (6) with water. The display shows
Push milk frother
.
15. Push the milk frother (6) in to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet.
When the drink selection menu is shown in
the display, the appliance is ready for use.
Switching off the appliance
The factory settings of the fully automatic
espresso machine are programmed for
optimal performance. The appliance
switches off automatically after a specific
time (time span can be programmed, see
“Menu settings”
Shut off
).
Exception:
The appliance switches off with
-
out rinsing if only hot water or steam were
dispensed.
To switch the appliance off manually before
this, press the
e
off /
j
button (12). The
appliance rinses and switches off.
N.B.:
If the appliance is being used for the
first time, a service program has been run,
or the appliance has not been operated for a
long period, the first beverage will not have
the full aroma and should not be consumed.
When using the espresso machine for the
first time, you will achieve a suitably thick
and stable “crema” only after the first few
cups have been dispensed.
After extended use, water droplets may
form on the ventilation slots. This is normal.
Water filter
A water filter can prevent scale buildup.
Before a new water filter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water filter firmly into the
water tank with the aid of the measuring
spoon (18).
2. Fill the water tank (16) with water up to
the
max
mark.
3. Press and hold the
e
off /
j
button (12)
for at least three seconds. The menu
opens.
4. Press the
e
off /
j
button (12)
repeatedly until the display shows
No / Old filter
.
5. Select
Activate filter
with the upper
rotary knob (14).
6. Press the
start
button (10).
7. Place a receptacle with a capacity of
0.5 litres under the outlet (6c).
8. Press the
start
button (10).
9. Pull the milk frother (6) to open it.
10. Water will now flow through the filter to
rinse it.
11. Push the milk frother (6) in to close it.
12. Empty the container.
The appliance is ready to use once more.
Note:
Rinsing the filter simultaneously
activates the setting for the
Change filter!
display.
