9
en
TES503.. | 02/2014
The filter is no longer effective when the
Change filter!
display appears, or at
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement filters can be obtained from
retailers or from customer service
(see
“Accessories”). If no new filter is used, turn
the
filter
setting to
No / Old
.
Note:
You can use the filter indicator to
mark the month in which you inserted the
filter. You can also mark the month in which
you will need to replace the filter next (at
the latest after two months).
Note:
If the appliance has not been used
for a prolonged period (e.g. vacation) the
filter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.
Menu settings
You can adapt the appliance to your indi
-
vidual needs in the menu settings.
1. Hold the
e
off
/
j
button (12) down for
at least 3 seconds.
2. Press the
e
off
/
j
button (12) repeat
-
edly until the required menu item
appears in the display.
3. Select the required setting with the
upper rotary knob (14).
4. Confirm by pressing the
start
button (10).
To leave the menu without making any
changes, turn the rotary selector to
Exit
and
press the
start
button (10).
You can set the following:
Shut off
Here you can set the time span after which
the appliance automatically switches off
following the last drink preparation. A time
between 15 minutes and 4 hours can
be set.
To save power you can specify a
shorter period.
Filter
Here you can set whether a water filter is
being used. If a water filter is not being
used, turn the setting to
No / Old
. If a
water filter is being used, turn the setting to
Activate filter
. New water filters have to
be rinsed before use (see “Water filter”).
Start Calc‘n‘Clean
The service programmes (
Calc‘n‘Clean
/
descaling
/
cleaning
) can be selected
manually here. Press the
start
button (10)
and run the selected programme
(see “ Service Programmes”).
Temp.
The brewing temperature (
high
/
middle
/
low
) can be set here.
Language
The display language can be set here.
Water hardness
The water hardness setting can be adjusted
on this appliance. It is important to set the
water hardness correctly, so that the appli
-
ance indicates accurately when the descal
-
ing programme should be run. The factory
setting for the water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.
Dip the test strip briefly in water, gently
shake off any drips, and check the result
after one minute.
