20
en | Camera Tilt and Pivot Adjustments
UMS Series Public View System
F01U029703 | 1.0 | 2006.07
Installation Manual
Bosch Security Systems, Inc.
8.5
Focusing the Camera
Adjust the focus on the camera by adjusting the rings around the lens until the picture is sharp
and clear. If the camera is angled to one side, there is a sliding black mask behind the front
window with a hole for the camera. Adjust the camera to the proper tilt position, see
Figure 8.1
on page 17 and
Figure 8.3
on page 19 for your camera series, and then slide the
black mask until none of it shows in the picture.
8.6
Light Sensor
The monitor display switches to the Power Save mode approximately one (1) minute after a
reduction in light is detected. The screen turns black and displays the following message
DPMS
Power Save Mode
. When the sensor detects light, the monitor automatically switches to the
ON mode.
i
NOTICE!
The looping output video is still active so that external recording continues in the
Power Save mode.
