28
| English
Cause
Corrective measures
Interfering objects are within
the sensor range
(6)
Remove all interfering objects (e.g. watches, bracelets,
rings, etc.) from within range of the sensor
(6)
. Do not
hold the measuring tool close to the sensor.
Ambient temperature too
high/too low
Only use the measuring tool in the operating temperat-
ure range.
Strong temperature variation Allow the measuring tool to reach the correct temperat-
ure.
The measuring tool monitors correct operation in every measurement. If a de-
fect is detected, the display will indicate only the symbol shown opposite. In
this case, or if you are unable to rectify an error using the other corrective
measures mentioned, send the measuring tool to an authorised
Bosch
after-sales service
centre.
Error during measurement using <Wood> operating mode
Cause
Corrective measures
Light-up ring lights up red even though there are no wooden beams in the wall.
Water-filled plastic pipe
Water-filled plastic pipes in dry walls are also displayed
in
<Wood>
operating mode.
Wall is not a dry wall
<Wood>
operating mode is only designed for dry walls.
Inhomogeneous dry wall
Dry walls made from coarse chipboard can be highly in-
homogeneous and cause incorrect measurements. For
this reason, start the measurement at a different place
on the wall and measure at a different height. If this does
not help, hold an additional plasterboard panel on the
wall and perform the measurement on this.
Measuring tool placed onto
the wall very slowly
Place the measuring tool onto the wall quickly.
Uneven contact with the wall When taking measurements, always hold the measuring
tool so that contact with the wall is as even as possible
and do not tilt the measuring tool.
No wooden beams are found.
Measured section too short
Start the measurement at a different place on the wall
and move the measuring tool over a larger section.
1 609 92A 6H8 | (02.07.2021)
Bosch Power Tools
Summary of Contents for UniversalDetect
