Common AutoDome User Commands (unlocked)
This chapter details the commonly used Bosch keyboard setup commands. See
Section 6 Keyboard Commands by Number, Page 41, for a complete list of commands.
Setting AutoPan Mode
AutoPan mode pans the AutoDome camera 360º or pans between user defined limits (when
programmed). The AutoDome camera continues to pan until stopped by moving the joystick.
To pan 360º:
1.
Press ON-1-ENTER.
2.
Move the joystick to stop the pan.
To set left and right pan limits:
1.
Move the camera to the starting position and press SET-101-ENTER to set the left limit.
2.
Move the camera to the end position and press SET-102-ENTER to set the right limit.
To start AutoPan between limits:
1.
Press ON-2-ENTER.
2.
Move the joystick to stop the pan.
Setting Preset Shots
Preset shots are saved camera positions. Shots are saved as scenes, therefore, the terms
SHOT and SCENE are used interchangeably.
To set a Shot:
1.
Move the camera to the position you want to save.
2.
Press SET-#-ENTER where # can be a number from 1 to 99 that identifies the camera
position of the scene.
3.
To specify a title for the shot, see the procedure below.
To view a Shot:
4
Press SHOT-#-ENTER where # is the number of the scene position you want to view.
To store or clear a Shot:
1.
Press SET-100-ENTER to access the Store/Clear Scene Menu.
2.
Follow the on-screen instructions.
To disable overwrite confirmations:
If you overwrite a preset shot the AutoDome issues a confirmation message prompting you
approve the overwrite. To disable this confirmation message issue the OFF-89-ENTER
command.
Specifying a Shot or a Sector Title
The AutoDome provides an alphanumeric character palette used to specify a title for a shot
(scene) or for a sector (zone).
1.
To specify a title, navigate to the shot or scene:
2.
–
for a shot: set a new shot or view a stored shot then press ON-62-ENTER.
–
for a scene: move the AutoDome to the scene (zone) then press ON-63-ENTER.
3.
Use the joystick to move the cursor to highlight a character.
4.
Press Focus/Iris to select the character.
5.
Continue to select characters (up to 20) until you have created the title.
6.
To clear a character from the title:
7.
–
Use the joystick to highlight the Clear OR Position Character prompt.
3
3.1
3.2
3.3
28
en | Common AutoDome User Commands (unlocked)
AutoDome 600 Series Analog PTZ
Camera
2014.11 | 2.1 | F.01U.270.005
User Manual
Bosch Security Systems, Inc.
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en User Manual ...
Page 2: ......
Page 67: ......
