–
Move the joystick left or right until the cursor is below the title character you need to
clear.
–
Press Focus/Iris to clear the character.
–
Move the joystick up to bring the cursor back into the character palette.
8.
To save the title:
9.
–
Use the joystick to highlight the Exit prompt.
–
Press Focus/Iris to save the title.
Configuring Preposition Tours
A Preposition Tour automatically moves the camera through a series of preset or saved shots.
The VG5 Autodome has one (1) standard preset tour and one (1) customized preset tour. Tour
1 is a standard tour that moves the camera through a series of shots in the sequence they
were set. Tour 2 is a custom tour that allows you to change the sequence of shots in the tour
by inserting and deleting scenes.
To start Preposition Tour 1:
1.
Set a series of preset shots in the order that you want the AutoDome to cycle through.
2.
Press ON-8-ENTER to start the tour. The tour then cycles through the series of shots until
it is stopped.
To stop a Preposition Tour:
4
Press OFF-8-ENTER or move the joystick to stop either type of tour.
To add or remove scenes to Preposition Tour 1:
1.
Press SHOT-900-ENTER to access the Add/Remove Scenes Menu.
2.
Use the Focus/Iris buttons to add or remove the selected scene from the tour.
To start custom Preposition Tour 2:
4
Press ON-7-ENTER to start a tour. The tour cycles through the series of shots in the order
they were defined until it is stopped.
To edit a custom Preposition Tour 2:
1.
Press SET-900-ENTER to access the Add/Remove Menu.
2.
Press the Focus/Iris buttons to add or remove the selected scene.
To change the dwell period of a tour:
1.
Press ON-15-ENTER to access the Tour Period Menu.
2.
Select the tour (Tour 1 or Tour 2) and follow the on-screen instructions.
Notice!
Refer to the document “AUTODOME_OperationGuidelines_2014.pdf” for guidelines for
operating your camera using Guard Tours and Preset Tours. To access the document, go to
www.boschsecurity.com, navigate to the product page for your camera, and then locate the
document in the Documents tab.
Programming the Inactivity Operation
You can program the AutoDome to automatically change its operating mode after a period of
inactivity.
To access the Inactivity mode (locked command):
1.
Press OFF-90-ENTER to turn off the command lock.
2.
Press ON-9-ENTER to access the Inactivity Mode Menu.
3.
Select one of the following choices:
4.
3.4
3.5
AutoDome 600 Series Analog PTZ
Camera
Common AutoDome User Commands (unlocked) | en
29
Bosch Security Systems, Inc.
User Manual
2014.11 | 2.1 | F.01U.270.005
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en User Manual ...
Page 2: ......
Page 67: ......
