Hardware Configuration
The AutoDome is configured from the factory for RS-485 operation in Pelco Protocol Mode.
1.
Connect the controller's TX terminals to the AutoDome's TxD terminals. See the
AutoDome Modular Camera System Installation Manual for complete wiring instructions.
2.
Pan or tilt the keyboard joystick to confirm that control has been established to the
AutoDome (approximately five (5) seconds).
Notice!
If control is not established, ensure that the RS-232/RS-485 selector switch is positioned to
RS-485 (outward toward the LED lights). This switch is located on the bottom of the
AutoDome CPU board, under the camera head and next to the LED lights. See Figure 4.1.
Figure 4.1: RS-232/RS-485 Selection Switch
1
CPU Module
2
Switch Location
3
LEDs
4
RS485
Pelco Keyboard Commands
Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a Command Number and 2) a Function key input.
The AutoDome uses the PRESET command key to save and recall presets (pre-positions) 1
through 99.
Notice!
To save a preset, enter the desired number and hold the PRESET key for approximately two
(2) seconds. To recall a preset, enter the desired preset number (or command) and
momentarily press and release the PRESET key.
Pelco Keyboard Commands
Keyboard Command User Action
Description
0-Pattern
Press
Initiates recording continuous playback based upon
current Recording setting (A or B) in the Setup
Menu.
Press and hold Initiates recording based upon current Recording
setting (A or B) in the Setup Menu. Press ACK to
end recording.
1-Pattern
Press
Initiate Recording A continuous playback.
Press and hold Initiate Recording A. Press ACK to end recording.
2-Pattern
Press
Initiate Recording B continuous playback.
4.2.1
4.2.2
4.2.3
36
en | Alternative Control Protocols
AutoDome 600 Series Analog PTZ
Camera
2014.11 | 2.1 | F.01U.270.005
User Manual
Bosch Security Systems, Inc.
Summary of Contents for VG5 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en User Manual ...
Page 2: ......
Page 67: ......
