Activating and configuring storage media
Available media or iSCSI drives must be transferred to the Managed storage media list,
activated, and configured for storage.
Note:
A iSCSI target storage device can only be associated with one user. If a target is being used by
another user, ensure that the current user no longer needs the target before decoupling that
user.
1.
In the Storage overview section, double-click a storage medium, an iSCSI LUN or one of
the other available drives.
–
The medium is added as a target in the Managed storage media list.
–
Newly added media is shown as Not active in the Status column.
2.
Click Set to activate all media in the Managed storage media list.
–
The Status column shows all media as Online.
3.
Check the box in the Rec. 1 or Rec. 2 column to specify the recording tracks to be
recorded on the target selected.
Formatting storage media
All recordings on a storage medium can be deleted at any time. Check the recordings before
deleting and back-up important sequences on the computer's hard drive.
1.
Click a storage medium in the Managed storage media list to select it.
2.
Click Edit below the list.
3.
Click Format in the new window to delete all recordings in the storage medium.
4.
Click OK to close the window.
Deactivating storage media
A storage medium in the Managed storage media list can be deactivated. It is then no longer
used for recordings.
1.
Click a storage medium in the Managed storage media list to select it.
2.
Click Remove below the list. The storage medium is deactivated and removed from the
list.
Remote Video Device
This page provides information on the current recording status of the cameras connected to
VIDEOJET connect 7000. For easy identification, the IP address of the connected camera is
the heading for each corresponding information block.
The data in the fields in this window may be followed by an icon. Move the cursor over the
icon to show more details about each field.
Status
This field provides the status of the remote video device. Status descriptions include “Offline,”
“Recording,” and “Running.”
Last error
This field identifies when the last error occurred on the remote video device.
Recording target
This field identifies the recording target for the respective camera. This target is also the
source for the recordings available on the PLAYBACK page.
10.1.3
10.1.4
10.1.5
10.2
10.2.1
10.2.2
10.2.3
VIDEOJET connect 7000
Recording | en
39
Bosch Security Systems
Operation Manual
2014.10 | 1.4 | F.01U.291.524
Summary of Contents for VIDEOJET connect 7000
Page 1: ...VIDEOJET connect 7000 VJC 7000 90 en Operation Manual ...
Page 2: ......
Page 58: ......
Page 59: ......
