32
en | Transcoder
Videojet connect 7000
2019-08 | 1.7 | F.01U.291.524
Installation Manual
Bosch Security Systems
9
Transcoder
9.1
Transcoder Setup
Select a maximum of four cameras for which you want to offer transcoded video. Transcoding
is only available for cameras configured for Recording. Ensure that these cameras will have
recordings, either by configuring the cameras accordingly or by having the transcoder manage
recording.
9.1.1
Device [number]
4
Click the drop-down box directly below the Camera number (1, 2, 3 or 4). The system
scans your network for available devices and displays the list. This list includes MIC7000
cameras, MIC IP PSU devices, and analog cameras integrated into your system through a
single-channel encoder (in which case the corresponding encoder is listed for the
selection).
4
Select the desired device from the list. The parameters
Type
,
MAC
, and
Name
are
displayed, if available.
Notice!
If a MIC7000 camera is assigned to Camera 1 in the Transcoder Setup, it becomes “bound” to
the alarm inputs/outputs, the audio input/output, and the washer output provided by the
VIDEOJET connect 7000 device.
9.1.2
Name
4
Change the name if desired.
Do not use any special characters, for example
&
, in the name. Special characters are not
supported by the system's internal management.
Note that the name here is only used for the transcoder operation. Changes here will not
overwrite the name assigned to the camera or to the encoder on the corresponding
SETTINGS
page of the respective unit. The name that you enter here will be displayed in the title bar of
the transcoder Web pages and in the list of available cameras on the
PLAYBACK
page. If you
leave the field empty, the IP address of the unit is displayed.
9.1.3
Password
4
In the field
Password
, enter the service password of the selected camera.
4
Click
Set
to save the settings. For each connected camera a link is added in the title bar
next to the
SETTINGS
link stating the camera number 1 to 4 and its name or IP address.
9.1.4
Http port, Https port
By default, the numbers
HTTP port
and
HTTPS port
for the camera are set automatically for
each camera as an offset to the transcoder ports. The corresponding fields are marked by the
white outline and the highlighted connection line. You may change the numbers, if necessary,
on the page
Network Access
.
9.1.5
Configure Router
4
If your router has UPnP enabled, click
Configure Router
to save the settings to the
router. Otherwise, configure your router manually.
The cameras are now available for selection on the
PLAYBACK
page. Transcoding will only be
possible once recordings for the cameras are available.
Summary of Contents for VJC-7000-90
Page 1: ...Videojet connect 7000 VJC 7000 90 en Installation Manual ...
Page 2: ......
Page 57: ......
