34
en | Transcoder
Videojet connect 7000
2019-08 | 1.7 | F.01U.291.524
Installation Manual
Bosch Security Systems
9.2.4
Base resolution
Base resolution
Select the desired resolution for the video image.
The size of the video image depends on the settings of the connected device.
9.2.5
I-frame distance
I-frame distance
This parameter allows you to set the intervals in which the I-frames will be coded. 0 means
auto mode, whereby the video server inserts I-frames as necessary. An entry of 3 indicates
that only every third image is an I-frame. Note that the values supported depend on the
GOP
structure
setting. For example, only even values are supported with IBP; if you have selected
IBBP, only 3 or multiples of 3 are supported.
9.2.6
Min. P-frame QP
Min. P-frame QP
This parameter allows you to adjust the image quality of the P-frame and to define the lower
limit for the quantization of the P-frames, and thus the maximum achievable quality of the P-
frames. In the H.264-protocol, the Quantization Parameter (QP) specifies the degree of
compression and thus the image quality for every frame. The lower the quantization of the P-
frame (QP value), the higher the encoding quality (and thus the best image quality) and the
lower the frame refresh rate depending on the settings for the maximum data rate under
network settings. A higher quantization value results in low image quality and lower network
load. Typical QP values are between 18 and 30.
The basic setting Auto automatically adjusts the quality to the settings for the P-frame video
quality.
9.2.7
I/P-frame delta QP
I/P-frame delta QP
This parameter sets the ratio of the I-frame quantization (QP) to the P-frame quantization
(QP). For example, you can set a lower value for I-frames by moving the slide control to a
negative value. Thus, the quality of the I-frames relative to the P-frames is improved. The total
data load will increase, but only by the portion of I-frames. The basic setting Auto
automatically adjusts to the optimum combination of movement and image definition (focus).
To obtain the highest quality at the lowest bandwidth, even in the case of increased
movement in the picture, configure the quality settings as follows:
1.
Observe the coverage area during normal movement in the preview images.
2.
Set the value for
Min. P-frame QP
to the highest value at which the image quality still
meets your needs.
3.
Set the value for
I/P-frame delta QP
to the lowest possible value. This is how to save
bandwidth and memory in normal scenes. The image quality is retained even in the case
of increased movement since the bandwidth is then filled up to the value that is entered
under
Maximum bit rate
.
9.2.8
Deblocking filter
Deblocking filter
You can activate a filter that reduces blocking in the image, thereby providing a smoother
image. Please note that this option requires additional computing power.
Summary of Contents for VJC-7000-90
Page 1: ...Videojet connect 7000 VJC 7000 90 en Installation Manual ...
Page 2: ......
Page 57: ......
