Videojet connect 7000
Network | en
43
Bosch Security Systems
Installation Manual
2019-08 | 1.7 | F.01U.291.524
Notice!
Information about the service, registration process and available host names can be found at
DynDNS.org.
Provider
The value in this field defaults to dyndns.org. Select another option as necessary.
Host name
Enter the host name registered on DynDNS.org for the camera here.
User name
Enter the user name you registered at DynDNS.org here.
Password
Enter the password you registered at DynDNS.org here.
Force registration now
You can force the registration by transferring the IP address to the DynDNS server. Entries
that change frequently are not provided in the Domain Name System. It is a good idea to force
the registration when you are setting up the device for the first time. Only use this function
when necessary and no more than once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the camera, click the
Register
button.
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
12.3
Advanced
12.3.1
Cloud-based Services
The operation mode determines how the camera communicates with Bosch Cloud-based
Security and Services. For more information about these services and their availability, visit:
http://cloud.boschsecurity.com
–
Select
Auto
to allow the camera to poll the server a few times; if no contact is made, it
stops polling.
–
Select
On
to constantly poll the server.
–
Select
Off
to block polling.
12.3.2
RTSP port
12.3.3
Authentication (802.1x)
To configure Radius server authentication, connect the unit directly to a computer using a
network cable. If a Radius server controls access rights over the network, select
On
to activate
authentication to communicate with the unit.
1.
Enter the user name that the Radius server uses for the unit in the
Identity
field.
2.
Enter the
Password
that the Radius server expects from the unit.
12.4
Network Management
12.4.1
SNMP
The camera supports the SNMP V1 (Simple Network Management Protocol) for managing and
monitoring network components, and can send SNMP messages (traps) to IP addresses. It
supports SNMP MIB II in the unified code.
Summary of Contents for VJC-7000-90
Page 1: ...Videojet connect 7000 VJC 7000 90 en Installation Manual ...
Page 2: ......
Page 57: ......
