44
en | Network
Videojet connect 7000
2019-08 | 1.7 | F.01U.291.524
Installation Manual
Bosch Security Systems
If
On
is selected for the SNMP parameter and a SNMP host address is not entered, the device
does not send the traps automatically and will only reply to SNMP requests. If one or two
SNMP host addresses are entered, SNMP traps are sent automatically. Select
Off
to
deactivate the SNMP function.
SNMP host addresses
To send SNMP traps automatically, enter the IP
address of one or two target devices here.
SNMP traps
To choose which traps are sent:
1.
Click
Select
. A dialog box appears.
2.
Click the check boxes of the appropriate traps.
3.
Click
Set
to close the window and send all of the checked traps.
12.4.2
UPnP
Select
On
to activate UPnP communication. Select
Off
to deactivate it.
When the Universal Plug-and-Play (UPnP) function is activated, the unit responds to requests
from the network and is automatically registered on the requesting computers as a new
network device. This function should not be used in large installations due to the large number
of registration notifications.
Note:
To use the UPnP function on a Windows computer, both the Universal Plug-and-Play Device
Host and the SSDP Discovery Service must be activated.
12.4.3
Quality of Service
The priority of the different data channels can be set by defining the DiffServ Code Point
(DSCP). Enter a number between 0 and 252 as a multiple of four. For alarm video you can set
a higher priority than for regular video and you can define a Post Alarm Time over which this
priority is maintained.
12.5
Switch Configuration
Ethernet flow control is a mechanism for temporarily stopping the transmission of data using
the PAUSE frame in order to clear the existing buffers.
By default, flow control is enabled. Bosch recommends to use it for the daisy chain
configuration, but to disable it if the VIDEOJET connect 7000 unit is connected as a single
unit.
To enable flow control for any or all of the RJ45 ports (POE, ETH1, ETH2) or either or both of
the SFP ports (Fiber 1, Fiber 2) on the VIDEOJET connect 7000 unit, check the box under the
appropriate column.
Note:
Lower bandwidth links may delay the overall network
12.6
Accounts
Four separate accounts can be defined for posting and recording export.
Type
Select either FTP or Dropbox for the account type.
Before using a Dropbox account ensure that the time settings of the device have been
correctly synchronized.
Account name
Enter an account name to be shown as the target name.
Summary of Contents for VJC-7000-90
Page 1: ...Videojet connect 7000 VJC 7000 90 en Installation Manual ...
Page 2: ......
Page 57: ......
