Bosch WAK20200ME, Instruction Manual And Installation Instructions

Programme default settings       

en

17

0

Programme default 

settings

Programme default settings

The temperature, spin speed and 

programme duration ("Ready in" time) 

for all programmes are preset at the 

factory.
These are displayed in the display panel 

after selecting the programme.
You can change the default settings as 

follows.

Temperature (Temp °C)

Depending on the programme 

progress, you can change the preset 

temperature (in °C) before and during 

the programme. 
To do this, repeatedly select the 

corresponding button until the required 

setting is displayed.
The maximum temperature that can be 

set depends on the programme which 

has been selected.
Overview of programmes 

~

 Page 14

Spin speed (rpm 

0

)

Depending on the programme 

progress, you can change the spin 

speed (in rpm; rotations per minute) 

before and during the programme. 
To do this, repeatedly select the 

corresponding button until the required 

setting is displayed.
Setting – – – 

0 

: Rinse hold = without 

final spin, the laundry remains in the 

water after the final rinse.
You can select "Rinse hold" to prevent 

creasing if the laundry will not be taken 

out of the washing machine immediately 

after the programme has ended.
The maximum speed that can be set 

depends on the model and programme 

that have been selected.

Overview of programmes 

~

 Page 14

Ready in time (Ready in)

When you select the programme, the 

relevant programme duration is 

displayed.
The programme duration is 

automatically adjusted when the 

programme is running. Changes to the 

programme default settings or 

programme settings also change the 

programme duration.
Before starting the programme, the 

programme end ("Ready in" time) can 

be preselected in increments of one 

hour (h = hours) up to a maximum of 24 

hours. 
To do this, repeatedly select the 

corresponding button until the required 

setting is displayed.

Note:  

The programme duration is 

included in the selected "Ready in" time.

After the start, the preselected time e.g. 

8 h

 is displayed and the time counts 

down to the start of the wash 

programme. The programme duration is 

then displayed, e.g. 

2:30

(hours:minutes).

Changing the preselected time:

You can change the preselected time 

after the start of the programme as 

follows:

1.

Press Start/

Pause

A

2.

Press the 

"Ready in"

 button 

repeatedly until the required number 

of hours is displayed. 

3.

Press the 

Start

/Pause

 A

 button.

Adding laundry while the preselected 

time continues running:

1.

Press Start/

Pause

A

2.

The symbols 

YES

 and 

¼

 light up on 

the display panel. The washing 

machine door can be opened and 

laundry can be added.

3.

Close the washing machine door.