Bosch WAK2020SGC, Instruction Manual And Installation Instructions

en

    Operating the appliance

20

■

E

 flashes: The childproof lock is 

active and the programme selector 

was adjusted. To prevent the 

programme from stopping, turn the 

programme selector back to the 

original programme. The symbol 

lights up again.

Note:  

The childproof lock can remain 

activated until you wish to start the next 

programme, even after switching off the 

machine. 

You must then deactivate the childproof 

lock before starting the programme and 

activate it again as necessary once the 

programme has started.

Adding laundry

After starting the programme, you can 

add or remove laundry as required.
To do this, press the Start/

Pause

A

button. 
The Start/Reload 

A 

indicator lamp 

flashes and the machine checks 

whether it is possible to add laundry. 

Note:  

Do not leave the washing 

machine door open for too long when 

adding laundry as water from the 

laundry may leak out.

If the display panel shows:

■

Both

 the 

YES

 and 

¼ 

symbols lit up, 

it is possible to add laundry.

■

A flashing 

NO

 symbol, wait until 

YES

and 

¼ 

light up. 

Do not open the door until 

both

 the 

YES

 and the 

¼ 

symbols are lit.

■

A flashing 

NO

 symbol, it is not 

possible to add laundry. 

For safety reasons, the washing 

machine door remains locked when 

the water level or temperature is 

high, or while the drum is rotating, 

and it is not possible to add laundry.

To continue the programme, press 

the 

Start

/Pause 

A 

button. The 

programme continues automatically.

Changing the programme

If you have started the wrong 

programme by mistake, you can 

change the programme as follows:

1.

Press Start/

Pause

A

.

2.

Select the other programme.

3.

Press 

Start

/Pause

A

. The new 

programme starts from the 

beginning.

Cancel the programme

Programmes at high temperatures:

1.

Press Start/

Pause

A

2.

To cool the laundry: Select

 O

 Rinse

.

3.

Press 

Start

/Pause

A

.

For programmes at low temperatures:

1.

Press Start/

Pause

A

.

2.

Select 

0

 Spin

 or 

[

Empty

.

3.

Press 

Start

/Pause 

A

.

Programme end during rinse 

hold

– – – 

0

 appears on the display panel 

and the Start/Reload button indicator 

lamp flashes.
To end the programme, set the 

programme selector to 

0 

Spin /

[

 Empty or select a spin speed. Then 

press the 

Start

/Pause 

A

 button.

Programme end

End

 appears on the display panel and 

the Start/Pause button indicator lamp is 

off.
If the 

9

 symbol appears on the display 

panel, the washing machine has 

detected too much foam during the 

wash programme and automatically 

switched on a rinse cycle to remove the 

foam.

Note:  

Add less detergent for the next 

washing cycle with the same load.