Positioning and connecting
en
37
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Grounding Instructions
:
Warning
Danger of death!
Improper connection of the ground may
result in electric shock. Have the
appliance checked by a qualified
technician or licensed electrician if you
are in doubt as to whether the washing
machine has been properly grounded.
This appliance must be grounded. In the
event of malfunction or breakdown,
grounding will reduce the risk of electric
shock by providing a path of least
resistance for the electric current. This
appliance is equipped with a cord that
has an equipment grounding conductor
and a grounding plug. The plug must be
plugged into an appropriate outlet that
is properly installed and grounded in
accordance with local codes and
ordinances. To ground the appliance
use a 3 pin plug and properly grounded
socket of 16 A rating.
Notes
■
Do not modify the plug provided with
the appliance. If the plug will not fit
into outlet have a properly grounded
outlet installed by qualified
electrician. Do not cut, remove or
bypass the grounding prong on the
washing machine power cord plug.
■
The wiring for the eletrical outlet
circuit must be sufficient to meet the
appliance requirements. Use of
Ground Fault Circuit Interrupter
(GFCI) is recommended.
■
Do not use the machine with an
extension box, extension cord, spike
busters etc., as this may lead to
improper grounding conditions.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
■
Never use a damaged machine.
Inform your after-sales service.
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Connect the mains plug.
4.
Turn on the water tap.
5.
Close the washing machine door (do
not load any laundry).
6.
Select the
l
Drum Clean
programme.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
compartment
II
.
9.
Pour standard detergent into
compartment
II
.
Note:
To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.
Close the detergent drawer.
11.
Press
Start
/Reload
A
.
12.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
