Operating the appliance
en
17
1
Operating the
appliance
Operating the appliance
Preparing the washing
machine
Note:
The washing machine
must be
correctly installed
and
connected
.
From
1.
Connect the mains plug.
2.
Turn on the water tap.
3.
Open the door.
4.
Check that the drum is completely
drained. Drain if necessary.
Select programme/switch on
the appliance
Note:
If you have activated the
childproof lock, you must first deactivate
it before you can set a programme.
Use the programme selector to select
the required programme. Can be turned
in either direction.
The machine is switched on.
The display panel shows the following
information consecutively for the
selected programme:
■
The programme duration,
■
The preset temperature,
■
The preset spin speed and
■
The maximum load.
Change the programme
default settings
You can use the default settings or
change them.
To do this, repeatedly select the
corresponding button until the required
setting is displayed.
The settings are activated without
needing to be confirmed.
They are not saved when the appliance
is switched off.
Programme default settings
Overview of programmes from
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The indicator lamp for the button lights
up if a setting is active.
The settings are not saved when the
appliance is switched off.
Additional settings
Overview of programmes from
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
Summary of Contents for WAK2427SKE
Page 39: ...6 ...