Positioning and connecting
en
37
■
The mains plug must be freely
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(2-pole switch-off) must be built into
the permanent installation in
accordance with electrical
installation regulations.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
.
■
Never use a damaged machine.
Inform your after-sales service.
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Connect the mains plug.
4.
Turn on the water tap.
5.
Close the washing machine door (do
not load any laundry).
6.
Select the
i
Cottons
programme
and set the temperature to
90 °C
.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
compartment
II
.
9.
Pour standard detergent into
compartment
II
.
Note:
To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.
Close the detergent drawer.
11.
Press
Start
.
12.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply
3.
Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked
4.
Disconnect the washing machine
from the mains.
5.
Remove the hoses.
Summary of Contents for WAK2427SKE
Page 39: ...6 ...
