en
Cleaning and servicing
44
5.
Insert the maintenance flap and
lock it into place.
1
1
2
6.
Close the maintenance flap.
16.6 Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
1.
Switch off the appliance.
2.
Disconnect the appliance's mains
plug from the power supply.
3.
Loosen the hose clamp and care-
fully remove the water outlet hose.
Residual water may leak out.
4.
Clean the water outlet hose and si-
phon connecting piece.
5.
Reattach the water outlet hose and
secure the connection point using
the hose clamp.
16.7 Clean the water inlet fil-
ters.
Emptying the water inlet hose
1.
Turn off the tap.
2.
Set a programme, except for
Rinse
,
Spin
or
Drain
.
3.
Start the programme and leave it
to run for approx. 40 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.