en
operation
30
The activated "Ready in" time is
paused.
2.
Press
Termin.
repeatedly until
the display indicates the desired
"Ready in" time.
3.
Press
Inicio / Pausa + Carga
.
The changed "Ready in" time is ac-
tivated.
13.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
Inicio /
Pausa + Carga
.
3.
To resume the programme, after
the desired soaking time, press
Inicio / Pausa + Carga
.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
"Starting the programme", Page 29
1.
Press
Inicio / Pausa + Carga
.
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
Inicio / Pausa + Carga
.
13.11 Cancelling the pro-
gramme
1.
Press
Inicio / Pausa + Carga
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→
3.
Remove the laundry.
→
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡
Rinse Stop is activated.
→
¡
The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1.
Set the programme or a pro-
gramme for draining the water.
→
2.
Press
Inicio / Pausa + Carga
.
13.13 Unloading the laundry
1.
Open the door.
2.
Remove the laundry from the
drum.
13.14 Switching off the appli-
ance
1.
Turn the programme selector to .
2.
Turn off the tap.
Summary of Contents for WAN24268ES
Page 51: ......